Triumph Scrambler 1200 XE - Owner's Manual > Side Stand

Warning

The motorcycle is fitted with an interlock system to prevent it from being ridden with the side stand in the down position.

Never attempt to ride with the side stand down or interfere with the interlock mechanism as this will cause a dangerous riding condition leading to loss of motorcycle control and an accident.

Warning

Do not lean, sit or climb on the motorcycle when it is supported on the side stand.

This may cause the motorcycle to fall over leading to motorcycle damage and an accident.

1. Side stand

The motorcycle is equipped with a side stand on which it can be parked. When using the side stand, always turn the handlebars fully to the left and leave the motorcycle in first gear.

Whenever the side stand is used, before riding, always make sure that the stand is fully up after first sitting on the motorcycle.

For instructions on safe parking, refer to the 'How to Ride the Motorcycle' section.

Centre Stand (if fitted)

Warning

Do not lean, sit or climb on the motorcycle when it is supported on the centre stand.

This may cause the motorcycle to fall over leading to motorcycle damage and an accident.

Caution

Do not use body panels or the seat as a handhold when placing the motorcycle on the centre stand as this will cause damage.

1. Centre stand

To set the motorcycle on the centre stand:

• Hold the motorcycle upright.
• Step down firmly on the foot finder part of the stand.
• Lift the motorcycle up and to the rear using the passenger grab rail as a handhold.

For instructions on safe parking, refer to the How to Ride the Motorcycle section.

Side Panels

The left hand side panel can be removed to gain access to the fuse box.

Left Hand Side Panel Removal

To remove the left hand side panel:

• Grasp the panel firmly and pull the panel away from the motorcycle until it is free from the three retaining grommets (leaving the grommets in place).

Left Hand Side Panel Refit

1. Side panel (left hand side)
2. Grommets

To refit the left hand side panel:

• Position the three locating dowels to the grommets, then press firmly to secure the panel.
• Finally, grasp the panel and make sure that it is fully retained.

Tool Kit

The tool kit consists of an adjustment tool.

1. Adjustment tool

The adjustment tool is attached to the inside of the right hand side panel.

See also: