Ducati Scrambler 800 - Service manual > Removing the front footpeg support

LH footpeg holder

Release the gearbox rod by loosening screw (1).

Loosen the screws (2) and (3) retaining footpeg holder to the frame.

Undo screw (4) securing footpeg holder to exhaust.

Remove the LH footpeg holder from the frame.

RH footpeg holder

Remove the silencer (Removing the silencer).

Loosen the screws (5) and (6) retaining footpeg holder to the frame.

Remove footpeg holder (7) by releasing the rear braking system.

Refitting the front footpegs

Position spring (11) so that it engages in the footpeg holder bracket as shown in the figure.

Fit front footpeg (10) in place.

Apply the recommended grease to pin (9).

Fit pin (9) as shown.

Lock shaft using circlip (8).

Removing the front footpegs

Remove the footpeg holders (Removing the front footpeg support).

Remove the circlip (8) thereby releasing the pin (9).

Slide out pin (9), while supporting the footpeg (10).

Slide out footpeg (10) from its seat and collect spring (11).

See also: