Ducati Scrambler 800 - Service manual > Removing - refitting the complete engine

Refitting the engine

Fit the engine in the frame.

Lubricate screws (1) with the indicated grease and tighten to a torque of 60 Nm +- 5%.

Refit the swinging arm (Refitting the rear swinging arm).

Refit the rear wheel (Refitting the rear wheel).

Refit the footpeg holder plates (Refitting the footpeg support).

Refit the side stand (Refitting the side stand).

Refit the clutch cable (Refitting the clutch assembly).

Refit the electric connections.

Refit the airbox (Refitting the airbox).

Refit the oil cooler (Refitting the lubrication system).

Refit the rear brake assembly (Refitting the rear brake control).

Refit the electric supports.

Refit the tank (Refitting the fuel tank).

Refit the fairings.

Refit the seat (Refitting the seat).

Removing the engine

Remove the seat (Removing the seat).

Remove the fairings.

Remove the fuel tank (Removing the tank).

Remove the electric supports.

Remove the side stand (Removing the side stand).

Remove the rear brake system (Removing the complete rear brake control).

Remove the oil cooler (Removing the lubrication system).

Remove the airbox (Removing the airbox).

Remove the exhaust system (Removing the exhaust system).

Remove the electric connections Remove the clutch cable (Removing the clutch assembly).

Use a vice to block the front wheel and an elastic band to retain the front brake lever.

Remove the footpeg holder plates (Removing the front footpeg support).

Remove the battery

Remove the swinging arm (Removing the rear swinging arm).

Position a support under the engine.

Remove the two pins (1) that retain the engine to the frame.

Remove the engine from the frame.

See also: