Yamaha XSR700 - Owner's Manual > Indicator lights and warning lights

Anti-lock Brake System (ABS) warning light

 Engine trouble warning light " "

Coolant temperature warning light " "

Oil pressure warning light " "

Left turn signal indicator light " "

 Neutral indicator light " "

High beam indicator light " "

Right turn signal indicator light " "

Immobilizer system indicator light " "

Turn signal indicator lights " " and" "

Each indicator light will flash when its corresponding turn signal lights are flashing.

Neutral indicator light " "

This indicator light comes on when the transmission is in the neutral position.

High beam indicator light " "

This indicator light comes on when the high beam of the headlight is switched on.

Oil pressure warning light " "

This warning light comes on if the engine oil pressure is low.

TIP

When the vehicle is turned on, the light should come on, go off briefly, and then remain on until the engine is started.

Otherwise, have a Yamaha dealer check the vehicle.

NOTICE

If the warning light comes on when the engine is running, stop the engine and check the oil level. If the oil level is low, add sufficient oil of the recommended type. If the warning light remains on after adding oil, stop the engine and have a Yamaha dealer check the vehicle.

Coolant temperature warning light " "

This warning light comes on when the engine is overheating. If this occurs, stop the engine immediately and allow the engine to cool.  For vehicles with a radiator fan, the radiator fan(s) automatically switch on or off according to the coolant temperature.

TIP

When the vehicle is turned on, the light will come on for a few seconds, and then go off. If the light does not come on, or if the light remains on, have a Yamaha dealer check the vehicle.

NOTICE

Do not continue to operate the engine if it is overheating.

Engine trouble warning light " "

This warning light comes on if a problem is detected in the engine or other vehicle control system. If this occurs, have a Yamaha dealer check the onboard diagnostic system.

TIP

When the vehicle is turned on, the light will come on for a few seconds and then go off. If the light does not come on, or if the light remains on, have a Yamaha dealer check the vehicle.

ABS warning light " "

This warning light comes on when the vehicle is first turned on, and goes off after starting riding. If the warning light comes on while riding, the anti-lock brake system may not work correctly.

WARNING

• If the ABS warning light does not turn off after reaching 10 km/h (6 mi/h), or if the warning light comes on while riding:
• Use extra caution to avoid possible wheel lock during emergency braking.
• Have a Yamaha dealer check the vehicle as soon as possible.

Immobilizer system indicator light " "

When the vehicle is turned off and 30 seconds have passed, the indicator light will flash steadily to indicate the immobilizer system is enabled. After 24 hours have passed, the indicator light will stop flashing, however the immobilizer system is still enabled.

TIP

When the vehicle is turned on, the light will come on for a few seconds, and go off. Otherwise, have a Yamaha dealer check the vehicle.

Troubleshooting

If a problem is detected in the immobilizer system, the light will flash in a pattern.

If the immobilizer system indicator light flashes in the pattern, slowly 5 times then quickly 2 times, this could be caused by transponder interference.

If this occurs, try the following.

1. Make sure there are no other immobilizer keys close to the main switch. Other immobilizer system keys may cause signal interference and prevent the engine from starting.

2. Use the code re-registering key to start the engine.

3. If the engine starts, turn it off, and try starting the engine with the standard keys.

4. If one or more of the standard keys do not start the engine, take the vehicle and all keys to a Yamaha dealer to have the standard keys re-registered.

See also: