Royal Enfield Bullet Trials Works Replica - Owner's Manual > Changing electrical components
HEADLAMP BULB REPLACEMENT
- Make sure the Ignition switch is in OFF position when replacing the bulb.
- Loosen the rim holding screw on top and take out the head light reflector.
- Disconnect the wiring coupler over the bulb.
- Remove the rubber grommet from the bulb.
- Press the clip by thumb to release the free end from bulb holder.
- Pull out the bulb.
ASSEMBLING THE HEAD LAMP BULB
1. Refix the new halogen bulb into reflector unit of the headlamp.
2. Gently press the bulb holding clip and lock the free end in its slot.
3. Fit the rubber grommet.
4. Connect the electrical connections carefully & assemble the headlamp in the reverse order of dismantling.
C A U T I O N
Never touch the bulb with your fingers, Finger prints will etch the glass and decrease bulb life. Always hold the bulb with paper or clean dry cloth during handling.
TAIL LAMP BULB
- Remove the tail light glass by unscrewing its mounting screw.
- Remove the tail light bulb from its holder.
- Replace the bulb.
- Assemble back the tail light in the reverse order of dismantling.
TRAFFICATOR BULB
- Remove the screws & take out trafficator glass cover.
- Press bulb gently & Turn anticlockwise to take out the bulb.
- Position the new bulb inside holder, ensuring that the pins in the bulb, match with the slots in the holder.
- Gently press the bulb and turn clockwise to lock the bulb in the holder.
- Refit the trafficator glass and screws, ensuring the lens slot / cut mark is at the bottom.
NOTE Make sure the Ignition switch is in OFF position when replacing the bulbs.
BRAKE PAD WEAR
- Brake pad wear depends upon the severity of usage, the type of riding and road condition.
Check the wear indicator mark on each pad. If either pad is worn to the wear indicator mark. Replace both pads as set. Visit royal enfield dealer for this service.
Check the wear indicator mark on each pad. If either pad is worn to the wear indicator mark. Replace both pads as set. Visit royal enfield dealer for this service.
See also:
Royal Enfield Bullet Trials Works Replica - Owner's Manual > Battery & maintenance
The Motorcycle is provided with 12V-12Ah MF Battery. Periodically check the battery for cleanliness and corrosion free terminals.
Royal Enfield Bullet Trials Works Replica - Owner's Manual > Fuse & carrier
Open the left side Tool box. The fuse holder is located inside with 9+3 fuses. Replace the required fuse with the spare fuse available in the fuse carrier.